AR15 Bundle

137,80148,90 (-7%)

Ajustable Gas block for AR15 - Clickable with 4 clicks / rev.

In stock

+5 Rnd Magazine Pad for AR-15 MAGPUL GEN M3 .223 Rem Magazine

Insufficient stock

Notify me when this item is on stock

SKU: AR15BUNDLE Categories: ,


Kit contains:

Component Descriptions:

This gas block is made for standard AR15 barrel diameter of 0.750 inch. Port hole is compatible with all standard gas tubes so it can be installed onto any length gas system.
Made from hard and resistant steel EU-42CrMo4. (USA-4140). It is same steel that most barrels are made of. Since almost all factory AR15 are over-gassed for improved reliability, for sport shooting it’s necessary to reduce amount of gases resulting in reduced recoil and improved target control, specially for fast follow up shots. Shooter can adjust how much gas travels to bolt carrier with clickable and completely repeatable setting using included long hex hey (Allen wrench). This key allows you to adjust the gas block anytime, even with hand-guard mounted. Clear and crisp clicks hold the position so there is no need for a locking screw. Gas block can easily be disassembled for cleaning and assembled in same position by counting clicks. Advantage with a clickable system is that you don’t need a locking screw and when you disassemble and clean your gun you simply fully tighten gas block and count clicks (e.g. 8 clicks) and when you assemble it back you fully tighten and unscrew 8 clicks. Gas block is produced with tight tolerances and highest quality machining.

Why is Armanov gas block better than competition:

  • Better material – hard and resistant steel EU-42CrMo4. (USA-4140)
  • Low profile so even ultra slim hand-guards fits without any problem.
  • Easy cleaning. You can fully disassemble gas block.
  • Front side adjustment. No hand-guard removal.
  • Included 200mm long hex key.
  • Adjustable clicks – no counter crew required.
  • Crisp 4 clicks per revolution. About 12 clicks of adjustable range.
  • Compatible with mil-spec gas tubes.
  • All screws are metric.
  • Spare retainers pins included for changing your barrel.
  • Engraved center lines for correct mounting.
  • Special funnel made from inside for better barrel fit.
  • Included thread lock for proper mounting.
  • Made in EU on high-end CNC machines

Easy add +5 capacity that will allow you to stretch your mags a little further between reloads.

Designed to use the factory spring, you simply remove the existing factory bottom plate and slip the +5 Rnd Magazine Pad for AR-15 extension in place. A socket screw holds the extension in place. The factory spring has more than enough energy and travel to feed ALL rounds into your weapon.

The design allows for easy removal so that you can take the entire magazine apart for cleaning

  • Quickly and easily attaches to and detaches from the magazine tube
  • One piece design; no small parts to keep track of
  • Minimal length addition to allow usage while in a prone position
  • CNC machined from solid piece od aluminum
  • Holds 25 rounds on the PMAG20
  • Holds 35 rounds on the PMAG30
  • Holds 45 rounds on the PMAG40
  • CNC machined from solid piece od aluminum
  • Anodized finish
  • Reverse compatible with GEN2 PMAGs
  • Made in EU


Additional information

Weight 450 g

+5 Rnd Magazine Pad for AR-15 MAGPUL GEN M3 .223 Rem Magazine

Reviews (0)

Submit your review


There are no reviews yet.


No products in the cart.